PPPoE Installation for Bipac 5200S Modem/Router.

Go to command prompt and check for IP Configuration. The ipconfig command should return the IP address as by default. If not, the network TCP/IP properties to be set to Obtain IP Address automatically for the following configuration.

Also ensure that the browser is not configured with proxy settings. Else you may not be able to open the web interface at all.

Open your favourite browser and type in the URL. Press ENTER to view the login page..

The default user name is admin and the password is also admin.

The status page will come up as shown below and change the PVC to PVC2.

Ensure that the status is Activated by selecting the radio button and ensure the values of VPI=0 and VCI=35, the ISP is set to Bridge Mode and then the encapsulation is set to RFC1483 Bridged IP LLC.

Ensure that the radio button Current Settings is selected and then press RESTART to save and reboot the router.

Simply Click OK.

Simply Click OK.

The interface has no log out option and hence click CANCEL and then close the browser subsequently. The modem/router is now set to operate in bridge mode...

Creating a PPPoE Connection on the desktop(Dailing From the Computer)

The procedure for creation of PPPoE connection for the broadband connection is bit different for different operating systems and the different router models.

  Windows 98, Windows me, Windows 2000 Operating Systems

A patch known as PPPoE is to be installed for these systems to enable the broadband connectivity. Installing the patch will create a connection on the desktop automatically. However, these modems have only one LAN port and hence an ethernet card in the computer is necessary..The patch can be downloaded from here.

  Windows XP and Windows 2003 Operating Systems

However, the connection can be created in Windows XP and Windows 2003 without installing the said patch. The procedure for doing so is available here.


Design downloaded from Free Templates - your source for free web templates