PPPoE Configuration of D-Link 103i Modem/Router. You need to enter 192.168.1.1 in the address bar as shown below in any of your favourite browser-

The default user name is admin and the password is also admin. Click OK to go the web interface as shown below:-

The status page will come up as shown and you need to click on Setup to see the picture below:-

Click on New Connection in the displayed window. Enter the settings as shown in the picture.

Click on Apply and click on Tools as shown in the picture

You will see these two messages coming up after you click RESTART The status page will come up again.

Do check for the connectivity.. The configuration of the Modem/Router in the bridge mode is now over. You now have to create a connection on the desktop...

Creating a PPPoE Connection on the desktop(Dailing From the Computer)

The procedure for creation of PPPoE connection for the broadband connection is bit different for different operating systems and the different router models.

Windows 98, Windows me, Windows 2000 Operating Systems

A patch known as PPPoE is to be installed for these systems to enable the broadband connectivity. Installing the patch will create a connection on the desktop automatically. However, these modems have only one LAN port and hence an ethernet card in the computer is necessary..The patch can be downloaded from here.

Windows XP and Windows 2003 Operating Systems

However, the connection can be created in Windows XP and Windows 2003 without installing the said patch. The procedure for doing so is available here.

Design downloaded from Free Templates - your source for free web templates