PPPoE Installation (Dailing From the Computer) PN 101E/U Modem

Open your favourite browser and type 192.168.1.1 in the address bar as shown below:-

Enter the username and password as indicated in the picture below:-

Clck on the Advance Setup as shown in the figure below

When you click on the WAN in the left pane you would see a list of PVCs in operation in the right pane and sleect one which reads VPI=0 and VCI=35 by clicking on the EDIT button in the extreme right.

Just look for VPI and VCI values as indicated and move further by clicking NEXT

Ensure the bridge mode is selected and ensure encapsulation is LLC/SNAP-BRIDGING and click NEXT to proceed further

No need to change any value and again click NEXT as indicated in the picture.

Ensure all the values are as shown in the picture below and proceed to SAVE the configuration.

The procedure for creation of a PPPoE connection on the computer is bit different for different operating systems and the different router models.

Creating a connection on the Computer for Pronet ADSL 101e_u Modem/Router

Windows 98, Windows me, Windows 2000 Operating Systems

A patch known as PPPoE is to be installed for these systems to enable the broadband connectivity. Installing the patch will create a connection on the desktop automatically. However, these modems have only one LAN port and hence an ethernet card in the computer is necessary..The patch can be downloaded from here.

Windows XP and Windows 2003 Operating Systems

However, the connection can be created in Windows XP and Windows 2003 without installing the said patch. The procedure for doing so is available here.

Design downloaded from Free Templates - your source for free web templates