PPPoE Configuration of Xavi X7721R+ Modem/Router.

Go to Local Area Connection Properties and set the TCP I/P settings as IP Number Subnet Mask as and Default Gateway as and then go to Command prompt and issue the command ping If you get the reply your network configuration is fine.

Also ensure that the browser is not configured with proxy settings. Else you may not be able to open the web interface at all.

Now Open your favourite browser and type in the URL. Press ENTER to view the login page..

The default user name is admin and the password is also admin. Click OK to go the web interface as shown below:-

The status page will come up as shown and you need to click on Connection Settings to see the picture below:-

Delete any existing connections by clicking Delete and then click on Create New Connection Service.

By default the DHCP server is not set to ON. If you wish you can start this service. Else you can skip this step.

The configuration of the Modem/Router in the bridge mode is now over. You now have to create a connection on the desktop...

Creating a PPPoE Connection on the desktop(Dailing From the Computer)

The procedure for creation of PPPoE connection for the broadband connection is bit different for different operating systems and the different router models.

  Windows 98, Windows me, Windows 2000 Operating Systems

A patch known as PPPoE is to be installed for these systems to enable the broadband connectivity. Installing the patch will create a connection on the desktop automatically. However, these modems have only one LAN port and hence an ethernet card in the computer is necessary..The patch can be downloaded from here.

  Windows XP and Windows 2003 Operating Systems

However, the connection can be created in Windows XP and Windows 2003 without installing the said patch. The procedure for doing so is available here.


Design downloaded from Free Templates - your source for free web templates